Boulder 2010 Spécifications télécharger pdf (Page 46)

4-12

PROGRAMMING FROM THE REMOTE

CONTROL

Programming may also be conveniently done from the remote

control. Similar to programming from the front panel, all programming

is done by pressing the PGM button which causes “PROGRAM MODE”

to be displayed in the left display. You may leave program mode

whenever “PROGRAM MODE” is showing in the left display by again

pressing the PGM pushbutton.

INPUTS

From “PROGRAM MODE” press the SRC button. “NUMBER?” will

be displayed and you may press the input source number button you

wish to program from ONE through SIX. If you selected ONE, then

“1.NAME?” will shown the left display and “YES” will show in the right

display. Press the DOWN button to choose “NO” if you do not want to

name the input. Press the SRC button again to continue.

If you chose to assign a name, then “1._INPUT 1” will be displayed

in the right display with a blinking cursor in the name’s first character.

Press the UP and DOWN buttons until the desired character appears.

Again press the SRC button to accept the displayed character and go to

the next character. Continue in this manner until all 10 characters are

set.

PROGRAMMING

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 64 65

Pas de commentaire

Boulder 2010 Spécifications Page 46